Docker修改默认地址172.17.0.1
参考链接https://blog.csdn.net/Dawn__Z/article/details/84746055**注: 可以直接尝试用第二种方法,经试验,第二种方法可行。**一.查看当前状态当前状态ifconfigdocker0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500inet 172.17.0....
参考链接
https://blog.csdn.net/Dawn__Z/article/details/84746055
**
注: 可以直接尝试用第二种方法,经试验,第二种方法可行。
**
一.查看当前状态
当前状态
ifconfig
docker0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
inet 172.17.0.1 netmask 255.255.0.0 broadcast 0.0.0.0
ether 02:42:18:22:59:cd txqueuelen 0 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
安装bridge网络工具
yum -y install bridge-utils
安装后,查看网桥列表
brctl show
bridge name bridge id STP enabled interfaces
docker0 8000.0242182259cd no
停止、删除网桥docker0
停止:
ip link set dev docker0 down
删除:
brctl delbr docker0
删除成功后,查看:
brctl show
bridge name bridge id STP enabled interfaces
创建新的网桥
brctl addbr bridge0
设置网桥IP
ip addr add 192.168.0.1/24 dev bridge0
6. 启动网桥
ip link set dev bridge0 up
启动成功后,查看:
brctl show
bridge name bridge id STP enabled interfaces
bridge0 8000.000000000000 no
复制代码
ifconfig
bridge0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.0.1 netmask 255.255.255.0 broadcast 0.0.0.0
ether ca:ed:3e:52:f1:ee txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
二.注意
删除bridge0之后,我尝试不好用,然后我又按照删除bridge0的方式,同样把docker0删除.
然后再配置文件时候,增加如下代码:
停止docker服务
sudo systemctl stop docker.service
1
修改 /etc/docker/daemon.json, 指定ip地址
vim /etc/docker/daemon.json
1
输入:
{
"bip": "172.18.0.1/24",
}
1
2
3
然后重启docker服务即可。
service docker restart
更多推荐
所有评论(0)